$27.00

 

A crucial component to your saw setup for our manually adjustable riving knife to fit (ARK), available in either left tilt or right tilt, and zero clearance (blank). We manufacture throat plates or inserts, for Delta Unisaws, Powermatic 63,  older Grizzly 1022 and 1023 left and right tilt, Jet CTAS-10, Craftsman 152, which measure 13-3/8″L x 3-3/4″W x 1/2″H.

Large throated JTAS-10XL and Xacta are a tad bit smaller than above, but we have throat plates for them as well.

Grizzly G0444 G0444Z, Jet JWTS-10, small throated JTAS-10, JCS-10, JTS-10, JWCS-10, which measure 12-1/2″L x 3-9/16″W x 1/2″H.

There are other manufacturers not listed that our throat plates will fit.  Just double check the dimensions of yours and I’m sure it will work.  These can also be cut, sanded, and planed down by you if they are a slightly smaller size.  There are also a few sizes that may be slightly larger.  The locking screws can be adjusted out up to an 1/8.”

Our table saw throat plates, or table saw inserts as some folks call them, are made out of pressed bamboo flooring, machined on a cnc router, and have red formica glued on the top for an ultimate smooth surface.  There are 4 leveling set screws installed for adjustment, and 2-3 locking screws on the sides.

Please drop us a line and ensure a great fit!

Clear
SKU: N/A Category:

Description

A crucial component to your saw setup for our manually adjustable riving knife to fit (ARK), available in either left tilt or right tilt, and zero clearance (blank). We manufacture throat plates or inserts, for Delta Unisaws, Powermatic 63,  older Grizzly 1022 and 1023 left and right tilt, Jet CTAS-10, Craftsman 152, which measure 13-3/8″L x 3-3/4″W x 1/2″H.

Large throated JTAS-10XL and Xacta are a tad bit smaller than above, but we have throat plates for them as well.

Grizzly G0444 G0444Z, Jet JWTS-10, small throated JTAS-10, JCS-10, JTS-10, JWCS-10, which measure 12-1/2″L x 3-9/16″W x 1/2″H.

There are other manufacturers not listed that our throat plates will fit.  Just double check the dimensions of yours and I’m sure it will work.  These can also be cut, sanded, and planed down by you if they are a slightly smaller size.  There are also a few sizes that may be slightly larger.  The locking screws can be adjusted out up to an 1/8.”

Our table saw throat plates, or table saw inserts as some folks call them, are made out of pressed bamboo flooring, machined on a cnc router, and have red formica glued on the top for an ultimate smooth surface.  There are 4 leveling set screws installed for adjustment, and 2-3 locking screws on the sides.

Please drop us a line and ensure a great fit!

Additional information

Tilt

Slotted Right Tilt, Slotted Left Tilt, Zero Clearance

Leave a Reply

Your email address will not be published. Required fields are marked *